I don’t have a ton of experience with these but my thought is — can you flatten the two areas where the walkers circular logo is and where the picture of the chips are — but they could be at different angles to each other too and one could have a slight extra angle in it —
then the rest of the bag could be fondant or buttercream and airbrushed to match the differing green coloration —
i would be sure the areas were flattened the way I wanted then airbrushing would go before placing the images —
and I would cut out the lettering and apply piece by piece —
If you print on to an icing sheet rather than wafer paper as long as the sheet hasn't completely dried out it really easy to apply to a wavy surface. Just cut it out, apply glue to the back and gently push it down. I tend to put a piece of kitchen towel over the top, as it's not completely dry some of the print does tend to come off or get smudged if your not really careful.
Quote by @%username% on %date%
%body%