meledmonds Posted 24 Feb 2012 , 4:04pm
post #1 of

Hi everyone!
After reading tons of post here, I decided to go with the SPS tacker plates and flat dowel system. I have stack cake that I just measured and my SPS plate supports will not go all the way down the bottom layer; essentially the bottom layer is taller than the supports / plate. Is this normal????? Will my top layer be supported appropriately even though the supports do not extend to the bottom of the supporting layer? TIA!

1 reply
leah_s Posted 24 Feb 2012 , 4:13pm
post #2 of

See answer on the other thread where you posted this.

Quote by @%username% on %date%

%body%