I made several. Actually was easier than it looked. Middle bottom is 2 layer 10" rd cake. shoulder is from 8" round cut down middle in half. lay both pieces of the cut 8" on the flat middlecut edge touching each other. this makes a stand up 1/2 cirlcle.....flat side down. then cut standing up 1/2 circle in half, down the middle at highest point.
put one on each side of 10" with the flat side against 10" these are the shoulders the head is an iced wig stand. white styrofoam. bought at beauty supply. I did carve about a 3/4 inch deep hole into the top of the 10" to make the styrofoam sink into the cake a little then I hammered a sharpened dowel rod through the head, the 10" and into the cake board. So, the light weight head didnt fall over. carved shoulders and neck a little and then iced.
Hope you can understand my explanation
Quote by @%username% on %date%
%body%