http://www.etsy.com/listing/119712698/chevron-set-1-5-closed-end-cutters
It says closed end...that means it won't make a continuous pattern, right?
Someone on FB sells one that makes a continuous chevron, but her stuff is so in demand, and very hard to get...
She posts when they're going in her shop and within minutes...gone.
http://www.etsy.com/listing/119712698/chevron-set-1-5-closed-end-cutters
They are closed ended. Due to the stretching...I am actually going to cut them in half next time. It's very hard to place them, while holding them. But I was working with a butter cream cake. I think it would probably be easier on a fondant cake to maneuver around.
I thought I would like the "endless" one that I saw on Etsy, but I do not want to roll that zig zag piece of fondant.
This is the link for the "endless" if anyone is interested.
http://www.etsy.com/listing/119839191/seamless-chevron-cutter-open-ended
I just tried some and found them to be worthless as they don't cut an even edge. If I wanted to spend four hours cutting the fraying edges off these I'd could do it by hand. http://www.ebay.com/itm/Chevron-Set-Open-Ended-Cookie-Cutter-MADE-TO-ORDER-Fondant-Cutter-for-Cake-/261334896358?ssPageName=ADME:L:OC:US:3160
AThere's a special technique you have to do for a successful cut.....of course that's not included with cutters...a friend told me what she does. ....mine turn out perfect.
All cutters are not created equal - you need to find a supplier that understands that and will put in that little bit extra to ensure a top product.
A
Original message sent by ddaigle
There's a special technique you have to do for a successful cut.....of course that's not included with cutters...a friend told me what she does. ....mine turn out perfect.
Original message sent by AZCouture
I can't imagine the cutters don't work, unless you have a defective product.
These cutters seemed very sharp, so I was mistakenly sure they were going to work and didn't try them until I was doing the cake. All I can say is beware of cutters made in a 3d printer
I do wish those green ones from Etsy had a sharper cut for sure. I really press down and do a little jiggle with the cutter to "hope" that it is cutting. Then I pick up the cutter...hopefully with the fondant still intact...look at the back side and wipe all around the edges....that is where there are always little frayed pieces of fondant due to the non sharpness of the cutter.
That cutter...in a metal form would be sooooo much better. But with my challenging math skills in cutting the angles out by hand...I will put up with the slight aggravation.
AA 3D printer, is that was those are done with? Makes sense now. You know, I use a cutter sometimes, but honestly the best results I've had is printing a template from Google, on cardstock (thick paper a must as far as I'm concerned). Take a box cutter blade, cause they're long and easy to hold, and make downward slices thru the fondant or gp. You can't screw it up, they're perfect every time. plus, since you can size it to what you need, you're not bound to what size a cutter provides.
Really, very precise method with box cutter blades. I let the cut pieces set up a bit, after I check to make sure they're all straight and lined up after.cutting.
AIf you use an electronic cutter Ike the Silhouette you can easily cut endless designs. THere is a tutoriall here. www.creativedesignsforcakes.blogspot.com
Quote by @%username% on %date%
%body%