Transporting A 3D Spongebob Cake

Decorating By cupncakes35 Updated 17 Nov 2012 , 6:14pm by CakeDiosa

cupncakes35 Posted 10 Nov 2012 , 1:21pm
post #1 of 4

Ai am attempting to do a siting 3d spongebob cake for a child organization. I will be putting dowels in the cake as well. Is there any advice for transporting the cake so it won't fall?

3 replies
CakesbyCarla Posted 10 Nov 2012 , 3:49pm
post #2 of 4

I don't know the dimensions of your cake, but you might be able to use a flange screwed into your board (center it in the middle of the cake) and put some pvc pipe up through the middle (cut a hole through your cake layers and cardboards) and stack with dowels. That will give you added stability.

cupncakes35 Posted 11 Nov 2012 , 8:55am
post #3 of 4

AThanks for your response. The cake is going to be two 9x13 sheet cakes cut in half, with cake boards between the levels. I was thinking about taking the top part off "where the sponge part stops and the white part of his pants start" and have it reconnected at the venue.

CakeDiosa Posted 17 Nov 2012 , 6:14pm
post #4 of 4

You will transport it complete.  I responded to your PM and will send you pics and instructions when I get your email address. 

Quote by @%username% on %date%