How Do I Use The Wilton Plunger Cutters?

Decorating By bostonterrierlady Updated 18 Jun 2012 , 4:45am by icer101

bostonterrierlady Posted 18 Jun 2012 , 4:07am
post #1 of 2

I tried using the plunger cutters for the hydrenga. Spelling? I cannot get it to work. Can someone tell me how to do this?

1 reply
icer101 Posted 18 Jun 2012 , 4:45am
post #2 of 2

Hi, are you rolling your g/p thin. You have to. Then press the cutter part onto the g/p. Twist it just a little. The petal should come up with the cutter when you lift it up. Then position it over the veiner , then press down plunger to create the veining. Lilft up ejector and press plunger to realise the flower. I had to do this several times with any of them to get the hang of it. I have used other hydrangea cutters, but not with the plunger. PME makes them also, i think. But just do as i have said(might take a time or two, Then you will get the hang of it. Good Luck. Rolling the g/p thin is the key to it.

Quote by @%username% on %date%