Cakegirl313 Posted 24 Feb 2012 , 2:41am
post #1 of

So I finally got an extruder. It is one of the push kinds. I used it tonight with gumpaste, but I don't know what the proper way to clean it is. Can anyone help please.....

Thanks

2 replies
KoryAK Posted 24 Feb 2012 , 3:26am
post #2 of

Is it plastic or metal? Mine is plastic and I soak the pieces in a bowl of water overnight then rinse in the morning and let them air dry. Metal you'd have to me more careful with. You could use the same procedure, but watch the timeline and keep it as short as possible and then put them into the oven for a few minutes to dry.

msthang1224 Posted 24 Feb 2012 , 3:30am
post #3 of

I have a metal one (Makins) and I wash it thoroughly with warm water and soap. If th substance refuses to come out, I DO soak it for a couple of hours or even overnight and its fine. I have never ran into the problem of rusting at all. I have had it for years icon_smile.gif

Quote by @%username% on %date%

%body%