Sps Questions For Foam Separators

Decorating By Tellis12 Updated 12 Aug 2011 , 3:44am by Pastazia

Tellis12 Posted 2 Aug 2011 , 1:06pm
post #1 of 2

I've been using SPS for a while but this weekend I'm doing the cake a little bit differently and it will have Styrofoam separator tiers. I've been doing a lot of research on how to put it all together but I wanted to run it by you all to make sure I'm doing it correctly.

The cake sizes will be 6,8,10,12,14,16. The dummies I bought are each 2" smaller than the cake that will sit on top of them. So it will be the 16" with a 12" SPS plate, then the 12" cake dummy, then the 14" cake, and so on. Is this correct? There isn't anything that really attaches the cake to the styrofoam? I confess to being fairly nervous about it because I've never done one with 6 tiers or separators like this before. Any other tips and advice are very, very welcome!

Thanks so much!

1 reply
Pastazia Posted 12 Aug 2011 , 3:44am
post #2 of 2

I'm about to do the very same thing on a smaller scale. How did it go? Do you have any tips?

Quote by @%username% on %date%