When printing an edible image, the icing sheet peels away from the backing just a little on the edge. (The side that feeds into the printer first.) When I put the sheet in the printer, I make sure there is not a corner folded back. Everything looks like it is adhered to the backing and flat so I don't know why it lifts. I have the print setting as normal and on matte photo paper. Any suggestions?
Yes... go in to your printer properties, under maintenance under custom settings. Click on paper abrasion, this will open up the rollers a bit. That may help. What brand are you using? Is it dry where it is falling off the backing? If it is, try adding a damp paper towel (small piece) and place it in the icing sheet bag against the backing. Leave it there 24 hours and see if they stick better to the backing.
I use to have that problem until I started using the sheets from icingimages.