CakesbyMichele Posted 7 Aug 2010 , 2:23pm
post #1 of

How do you make the head and neck for a 3d dinosaur so it stays supported in the cake? Thanks!!![/i]

2 replies
allaboutcakeuk Posted 7 Aug 2010 , 2:48pm
post #2 of
Quote:
Originally Posted by CakesbyMichele

How do you make the head and neck for a 3d dinosaur so it stays supported in the cake? Thanks!!![/i]




Hi Michele what is the style of cake you are doing - so the dino is sitting up. I did one where the dino was laying down in 3D so his neck was done in sponge - can offer advice on this if you need?

FullHouse Posted 7 Aug 2010 , 3:42pm
post #3 of

I also did one with neck laying down, used RKT for neck & tail and mini ball pan cakes carved for head. If I was doing the head raised, I would use all RKT and support with a combo of wooden & hollow plastic dowels.

Quote by @%username% on %date%

%body%