Any Tips On Making A Cupcake Cone Shaped Tower?

Baking By three_sets_of_twins Updated 6 Jul 2009 , 12:03am by three_sets_of_twins

three_sets_of_twins Posted 5 Jul 2009 , 5:01pm
post #1 of 6

hello everyone.
I would like to make a cupcake tower out of cone shaped styrofoam. I dont mean the layers on top of each other, I mean just a cone with cupcakes all around it. I know the basics, which is pretty much pin them to the cone 2 toothpicks per cupcake, but can anyone give me any tips or advice when it comes to making them? I havent been able to find any sites with decent instructions or photos...
Any information is highly appriciated!


Also, how on earth do I transport it? would I have to assemble it there?

5 replies
Kiddiekakes Posted 5 Jul 2009 , 6:01pm
post #2 of 6

I don't have any info about the cone shaped tower but I just read your Avatar...are you serious? 3 sets of twins!! My hat is off to you!!!


Welcome to Cake Central!!!!

three_sets_of_twins Posted 5 Jul 2009 , 6:09pm
post #3 of 6

lol.
yes, and a singleton. and thanks! and no treatments whatsoever...apparantly it "runs in the family" yet none of my cousins have has twins yet!!

Kiddiekakes Posted 5 Jul 2009 , 6:14pm
post #4 of 6

Man oh Man..I only have 2 and not twins but Good for you for doin it on your own!! I admire strong women...You are one!!!


LOL

notapro Posted 5 Jul 2009 , 7:10pm
post #5 of 6

Holy Cow! That's a lot of twins!

Did you see the post about the cupcake bouquet? http://www.cakecentral.com/cake-decorating-ftopict-636077.htm Although it's a ball, maybe you could use the same technique. I will say I have not tried it although I might do it tonight if I can make it out to the craft store after my kiddos get up from a nap. Looks cute!

Good luck! I hope you post a picture when you are done.

three_sets_of_twins Posted 6 Jul 2009 , 12:03am
post #6 of 6

thanks everyone, any ideas about how to deliver it? or should I have them pick it up? The cone is going to be around a foot and a half long...2 of them. Should I assemble it there?

Quote by @%username% on %date%

%body%